Epson Stylus Photo 960 Paper Jam Sensor Repair

The first time a paper crinkled upon loading in my new printer it damaged the jam sensor and the paper light
was always blinking with no remedy and could not print. Having had Epson send me a rebuilt unit (which was
dead on arrival I decided to look for a repair – here’s what I found – Apparently this is very common with these
printers – and not that hard to fix – just a poor design on their part.
Tools needed: Long regular screwdriver, Phillips screw driver, hot glue gun (or drop of epoxy), flashlight.
1. Turn off and unplug unit.
2. First remove the top cover by carefully popping it off the hinge pins manually.
3. Remove upper housing case– here is how:
Remove 4 phillips screws total – 2 just outside of cover hinges and two inside the front of the carriage
area – all visible from the top.
Once the screws are out lift the back of the case a little then with a long screw driver reach way down in the
front corners (2) and release two barbed “catches” that hold the front of the case down – flashlight is handy
here. Work the cover up and pull the ribbon cable out of the control switch circuit board (Note colored side
of ribbon cable is towards you) and peel the cable loose where it is stuck to the case to release case now
free. Manual service download

Canon BJC 2100 waste ink tank full

ERROR: Uesd ink tank is full

Waste Error Reset
1: Remove the Cartridge
2: Unplug the AC Power Cord
3: Open Front access panel
3: Hold down the RESUME/RESET button and plug in the AC power cord
4: Release RESUME/RESET after plugging in the AC Power cord.
5: Press the RESUME/RESET once within 5 seconds and release the RESUME/RESET .
6: Press and HOLD RESUME/RESET for two seconds or more and release it.
7: Press and HOLD RESUME/RESET for two seconds or more and release it.
8: Unplug AC Power Cord to set data

If it does not work. Try some more times. Thanks every one above.

Canon PIXMA iP1880 Inkjet Printer

Dear all reseter's

This is How to Reset Canon Pixma iP 1880 :
Waste Ink Counter Reset Manual for Service mode
1. Turn On iP1880
2. Push and Hold Resume button about 2 minutes
3. Release Resume button
4. Printer back to normal again
Sofware Download General Tool


# Driver Canon PIXMA IP1880 Download
# Driver IP1880 for Ubuntu

Canon iP1500 Resetter

Waste Ink Counter Reset. Manual for Service mode
1. Turn off the printer. And disconnect the printer cable.
2. Press and hold the POWER button, turn on the printer.
3. The indicator (L.E.D.) should be green.
4. Press and release the RESUME button , the indicator (L.E.D.) should be orange.
5. Press and release the RESUME button again, the indicator (L.E.D.) should be green
6. Release both buttons

resetter Canon IP1500 : Download

Driver Canon PIXMA IP1500 Download

Manual Reset_iP1500.pdf

Canon S450 Printer

1: Power off printer
2: Hold Resume button then press and hold POWER, the beeper will sound once.
3: Hold POWER and release RESUME
4: Press RESUME twice
5. Release Power button
6: When the indicator lights steady, press RESUME three(3) times. The indicator should be orange.
7: Press Power to set data

Canon PIXMA iP4500 Photo Printer USB Borderless Printing